Firmware for Bitmain
Send me firmwareFrequency up to 1175Mhz S9, above 850Mhz only for immersion cooling - up to 24TH.
Improving energy efficiency by 25% (S9 to 80J / T - 80W / 1TH) and up to 40% (L3 + 1.25W / 1MH).
Fan control, deactivation of control fans for immersion immersion cooling — no more fooling coolers.
Fan control, deactivation of control fans for immersion immersion cooling — no more fooling coolers.
Compatibility with all systems management and monitoring, AP. Parallel Dev fee mining, without drawdowns and suspension of main mining.
Compatibility with all systems management and monitoring, AP. Parallel Dev fee mining, without drawdowns and suspension of main mining.
Download firmware for Antminer Bitmain
If you use Antminer, the firmware will not only help to ensure reliable and stable operation but also increase the productivity of bitcoin and altcoin mining by up to 40%. Antminer ASIC firmware will help to reduce power consumption by up to 20%.
Firmware for antminer Bitmain, new features:
- Availability of profiles to overclock the asic and reduce power consumption;
- In the case of overheating, the profile could be downgraded automatically;
- Frequencies are adjusted automatically;
- Ability to prolong the life of fans, quiet start mode, temperature mode support;
- Possibility to change password en masse, transfer config with profile to many asics within one network;
- Virus destruction or isolation is automatic;
- There is a visible diode signal on the miner for easy device detection;
- Ability to demonstrate the power consumption of the miner.
Connecting and configuring antminer firmware
- First, it is necessary to open the "Upgrade" section, then go to "Mining configuration" to select the profile. Here you can also run the option "Asic boost."
- Chip autotuning, which allows adjusting the frequency of chips on the board, is performed within 60 minutes.
- If the hashrate drops, a manual reboot of the s9 is required, disconnect the power, and pull the pins out for a short period. If a 404 error occurs, you need to press CTRL+F5.
- When installing in immersion liquid s9/s9i/s9j models, it is possible to overclock up to 20-21 TH/s.